Pipe repair
replacing the cracked or corroded section in PPR, uPVC or galvanised iron
Hawalli
Leak repair in Bidaa
Leak repair in Bidaa addresses mixed pipe systems from different construction periods in an older district. We use modern detection equipment to pinpoint the fault without opening walls entirely. We thread a camera the size of string into the pipe and raise pressure gently to hear the leak and locate it precisely.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Bidaa is an old district with family houses from the sixties and seventies next to modern apartment blocks, and the oldest pipes are mild steel that corrodes inside from salt water near the seafront. Newer pipes are sheathed copper or PEX. When an old pipe cracks, water may seep slowly into foundations for months before surfacing. We first look for moisture marks on exterior walls and foundations, then run acoustic detection equipment around buried pipes to hear water spraying from distance, and finally dig only at that exact leak point.
Bidaa sits in Hawalli governorate near the Salmiya seafront and marine environment, a mixed district of older and newer buildings together.
We use acoustic detection equipment to trace buried pipes because damp soil near the seafront hides extra moisture quickly.
What leak repair covers
Joint and fitting repair
tightening or replacing a weeping fitting before damp spreads further
Targeted breaking
tiles or plaster opened only above the confirmed fault, nowhere else
Pressure test
pressurising the line after repair to confirm the leak is fully sealed
Scale clearance
clearing mineral scale from the pipe wall when the damaged section is replaced
Line reinstatement
reconnecting the line and restoring full flow before the technician leaves
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Leak repair
Other services in Bidaa
Non-destructive leak detection
See the detailsTank leak detection
See the detailsUnder-tile leak detection
See the detailsAcoustic leak listening
See the detailsCommon questions
Questions about Leak repair in Bidaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does internal corrosion of an old iron pipe show up right away?
No, corrosion happens slowly over years and water may seep quietly into foundations or exterior walls for a long time. When the hole becomes large enough the leak shows on a surface or in a lower room.
Can a very old pipe be repaired or must it be completely replaced?
If corrosion is in one spot only, we cut that section and solder a new joint. If the pipe is punctured in several places, full replacement is cheaper in the long run because repeated repairs will follow soon.
