Pipe repair
replacing the cracked or corroded section in PPR, uPVC or galvanised iron

Ahmadi
Leak repair in Zour addresses cooling and cold-water lines in major power generation stations. We pinpoint the faulty line precisely, remove the damaged fitting and install an approved connector tested under required pressure.
Power generation stations in Zour need continuous cooling, and cold water runs through coils inside concrete foundations and between wing partition walls. A small leak from these lines can corrode concrete if not repaired quickly. We use a camera to locate the leak and determine its depth and direction, then open locally, replace the pipe or joint, dry the area with compressed air before sealing.
Zour lies in Ahmadi governorate, a dense power generation zone where water is essential to continuous operations.
Every repair is tested by pumping water at 1.5 times normal operating pressure for thirty minutes.
replacing the cracked or corroded section in PPR, uPVC or galvanised iron
tightening or replacing a weeping fitting before damp spreads further
tiles or plaster opened only above the confirmed fault, nowhere else
pressurising the line after repair to confirm the leak is fully sealed
clearing mineral scale from the pipe wall when the damaged section is replaced
reconnecting the line and restoring full flow before the technician leaves
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We use a sound detector to pinpoint where water is escaping under the floor. Then we drill through concrete at the leak spot with a small diameter and feed a new steel pipe alongside the old one. This avoids opening the foundation over a large area.
The first leak is usually from pipe corrosion or a defect in the original joint. After our repair we visually inspect the entire line for other wear signs. If we find additional weak spots we recommend replacing that section in advance.
