Acoustic surface scan
Tracing the leak sound through tile and screed layers
Ahmadi
Under-tile leak detection in Jaber Al-Ali
Leak detection under tiles in Jaber Al-Ali relies on moisture measurement below the surface without drilling. We hold a sensor on dry tile then move it gradually toward the suspect area until it registers a moisture spike. This way we map the hidden water beneath the floor precisely. The result saves you from random breaking.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Jaber Al-Ali homes feature wide bathrooms with thick tile floors, and both hot and cold pipes beneath these tiles can be hard to tell apart. The moisture sensor reads water content gradually, not heat, so it catches any pipe leak regardless of temperature. We run the sensor in a grid pattern across the bathroom and log readings on a floor plan. If we find a high-moisture spot we check it twice to confirm.
Jaber Al-Ali is located in Ahmadi, a residential area where most floors are covered in thick Spanish tile that is hard to break.
Before starting we calibrate the moisture sensor on a known dry area and a wet patch to ensure accuracy.
What this service covers
Pressure line test
Isolating the suspect line and measuring pressure drop to confirm fault location
In-line camera check
Filming inside the pipe from the nearest access point to view the crack
Leak point marking
Marking the exact spot on the tile surface to minimise breaking area
Concealed branch check
Checking pipe branches hidden inside the adjacent ceiling or wall
Link to leak repair
Handing the confirmed location directly to the repair team
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Under-tile leak detection
Sabah Al-Ahmad City
See the detailsSabah Al-Ahmad Marine City
See the detailsSabahiya
See the detailsOther services in Jaber Al-Ali
Non-destructive leak detection
See the detailsTank leak detection
See the detailsAcoustic leak listening
See the detailsCamera leak detection
See the detailsCommon questions
Questions about Under-tile leak detection in Jaber Al-Ali
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the sensor distinguish between a pipe leak and normal air moisture in the air?
The sensor detects moisture directly beneath the surface, not floating air humidity. Pipe leak moisture concentrates under the tile and in the base layer, so the device reads consistently high as it passes over the affected zone.
After you find the leak, how long does repair take if we avoid breaking the whole floor?
Once we pinpoint the location we open only a small hole above the damaged pipe, repair the leak, then seal it with a tile patch and grout. The work takes two to three hours instead of a full day breaking the entire floor.
