Acoustic surface scan
Tracing the leak sound through tile and screed layers
Ahmadi
Under-tile leak detection in Sabah Al-Ahmad City
Leak detection under tiles in Sabah Al-Ahmad City relies on pressure testing closed supply lines without opening any joint. We fill the line with water, close the valve, wait an hour then read the pressure gauge. If pressure drops, there is a confirmed leak, and by comparing readings on cold and hot lines we identify which one. This eliminates random searching.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Purpose-built Sabah Al-Ahmad City houses units to high construction standards, and each unit has a pressure test point installed near the main meter. These points let us check pressure in each section of buried pipe independently. We test cold and hot water separately and record each reading, because the roof tank and heater may give different pressures. If the difference between first reading and reading after an hour is large, we know the leak is in that section.
New Sabah Al-Ahmad City in Ahmadi features modern runs designed with regular pressure test points to aid maintenance.
We test pressure early morning before water use begins to get an accurate baseline reading.
What this service covers
Pressure line test
Isolating the suspect line and measuring pressure drop to confirm fault location
In-line camera check
Filming inside the pipe from the nearest access point to view the crack
Leak point marking
Marking the exact spot on the tile surface to minimise breaking area
Concealed branch check
Checking pipe branches hidden inside the adjacent ceiling or wall
Link to leak repair
Handing the confirmed location directly to the repair team
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Under-tile leak detection
Other services in Sabah Al-Ahmad City
Non-destructive leak detection
See the detailsTank leak detection
See the detailsAcoustic leak listening
See the detailsCamera leak detection
See the detailsCommon questions
Questions about Under-tile leak detection in Sabah Al-Ahmad City
Need someone now? The emergency line is open any hour.
+965 9668 4964
If the pressure test fails, does it mean the entire pipe is split under the tiles?
Not necessarily. Pressure loss means there is a leak somewhere, but it could be a small hole in a joint or a pinhole in the pipe. After identifying the section we use an acoustic detector to narrow the location and gauge the leak size.
How many times must we test pressure to confirm a leak exists?
We test at least twice with an hour between readings to confirm the drop is consistent. If pressure stabilizes in the second test it confirms a steady leak, not accidental loss from water use during waiting.
