Acoustic surface scan
Tracing the leak sound through tile and screed layers
Farwaniya
Under-tile leak detection in Khitan Al-Jadida
Leak detection under tiles in Khitan Al-Jadida starts with an acoustic sensor we sweep across the dry surface to pinpoint hidden water. We do not break tiles before confirming the exact location. We test pressure and trace flow direction through the sand below the floor.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Khitan Al-Jadida homes are newer buildings with marble and thick-set tiles, and leaks there usually spread horizontally through the sand before surfacing far from the source. We divide the suspect area into a grid and tap gently on each tile to hear the difference between dry and saturated. Then we use thermal imaging to confirm moisture and narrow down the location before breaking.
Khitan Al-Jadida lies in Farwaniya governorate, a densely built residential area with modern-finished floors sitting on fine sand substrate.
Every water line is pressure-tested at full strength for an hour before acoustic scanning begins to rule out direct pipe failure.
What this service covers
Pressure line test
Isolating the suspect line and measuring pressure drop to confirm fault location
In-line camera check
Filming inside the pipe from the nearest access point to view the crack
Leak point marking
Marking the exact spot on the tile surface to minimise breaking area
Concealed branch check
Checking pipe branches hidden inside the adjacent ceiling or wall
Link to leak repair
Handing the confirmed location directly to the repair team
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Under-tile leak detection
Other services in Khitan Al-Jadida
Non-destructive leak detection
See the detailsTank leak detection
See the detailsAcoustic leak listening
See the detailsCamera leak detection
See the detailsCommon questions
Questions about Under-tile leak detection in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you tell if the leak is under the floor tiles and not inside the wall?
We start by measuring moisture at the wall base and floor with a digital meter. If floor moisture is higher than the wall, the leak runs horizontally beneath. We then trace the water path with acoustic sensing to confirm direction.
Is thermal imaging alone enough to spot the leak?
Thermal imaging shows moisture but does not locate its source, especially if flow runs horizontally under several metres. We combine it with pressure testing and acoustic scanning to reach the correct first break point.
