Acoustic surface scan
Tracing the leak sound through tile and screed layers
Ahmadi
Under-tile leak detection in Mina Abdullah
At Mina Abdullah where massive pipelines and tanks dominate, leak detection starts with quick thermal scanning of wet surfaces. We use ultrasonic sensors to trace water movement inside buried pipes beneath concrete wharves. We pinpoint the leak location on a 2D map before opening any passage. We deliver the report with immediate repair guidance.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
The terminal is packed with water supply lines for cooling and washing and drain lines from tanks and equipment. The tile and concrete in the wharves are very thick and full of sand and gravel, so breaking them deep is hard and costly. When water pools appear beside a storage tank we use ultrasound to tell whether the leak is from a side pipe or from the tank bottom itself. This saves the terminal the cost of digging a long trench under busy wharves.
Mina Abdullah sits in Ahmadi governorate with a desalination plant, storage facilities and intricate feed pipelines around the wharves.
We record ultrasound readings at 2-metre intervals along the pipe run to pinpoint the exact hole location.
What this service covers
Pressure line test
Isolating the suspect line and measuring pressure drop to confirm fault location
In-line camera check
Filming inside the pipe from the nearest access point to view the crack
Leak point marking
Marking the exact spot on the tile surface to minimise breaking area
Concealed branch check
Checking pipe branches hidden inside the adjacent ceiling or wall
Link to leak repair
Handing the confirmed location directly to the repair team
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Under-tile leak detection
Other services in Mina Abdullah
Non-destructive leak detection
See the detailsTank leak detection
See the detailsAcoustic leak listening
See the detailsCamera leak detection
See the detailsCommon questions
Questions about Under-tile leak detection in Mina Abdullah
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can you detect leaks from a tank buried under the concrete wharf?
Yes, ultrasound detects water escape sounds even through thick concrete. We place the sensor on the surface above the tank and move slowly until the sound pinpoints the leak spot precisely.
How long does pinpointing a leak under the terminal wharves take?
Usually 2 to 4 hours depending on pipe length and depth. We start with rapid thermal screening then use ultrasound to narrow the zone, much faster than random trench digging.
