Live pressure reading
Measuring cut-in and cut-out values before touching anything

Hawalli
The pressure switch in Shaab complaints arise when water sprays with too much force or when the pump fails to refill the tank properly. We inspect the control unit, pressure sensor and gauge readings, then adjust the pressure settings to match your tank height.
Shaab near Sha'ab Park contains multi-storey residential buildings with centralised water collection systems in basements. Each system has its own tank and automatic switch controlling feed from the main line. When the switch fails the pressure reading goes haywire, rising or dropping below target. We read the current pressure, measure tank height and then set the cut-in and cut-out zone with millimetre accuracy.
Shaab sits in Hawalli governorate, a dense beachfront district where centralised distribution systems are the standard setup.
Before leaving we run the pump through a full cycle from tank-empty to cut-out and record the pressure at each point.
Measuring cut-in and cut-out values before touching anything
Testing the air bladder charge and refilling it if pressure is lost
Cleaning contacts or fitting a new switch matched to pump capacity
Calibrating both thresholds precisely to prevent rapid on-off cycling
Inspecting wiring and terminal resistance at both switch contacts
Running the pump and confirming stable pressure through a full cycle
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Absolutely, a block needs higher pressure to push water up to upper floors, usually set between 4 and 5 bar. A single house with one tank may need only 3 bar, and the difference depends on height and horizontal pipe run.
Yes, sustained high pressure stresses welds and joints and shortens their lifespan. We choose cut-out and cut-in values carefully to keep them safe for your whole system and suggest a pressure relief valve if needed.
