Tank and line check
Tank size and pipe run checked before any pump is chosen

Hawalli
A roof tank pump installation in Bayan starts by checking the tank on your roof and measuring the incoming line pressure. We select the pump to match your tank size and daily household water demand. We fit the pump on the main feed line and test pressure and flow before we finish.
A typical family villa in Bayan has an aluminium or fibreglass roof tank with a feed line running down to the kitchen sink or ground-floor bathroom. Where natural pressure is weak or uneven, a pump delivers steady flow to every outlet. We measure incoming pressure and inspect the copper pipe run from tank to ground level before we size the pump.
Bayan is in Hawalli, a quiet villa district where roof tanks draw from deep wells and mains supply together.
We run the pump at full power for several minutes to check heat, noise and any leaks from every joint.
Tank size and pipe run checked before any pump is chosen
Type and capacity matched to actual tank height and demand
Pump seated on isolation pads to stop vibration reaching the structure
Inlet and discharge lines fitted with non-return and isolation valves
Outlet pressure measured and confirmed stable under normal fixture load
All joints inspected for leaks before the job is signed off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We install a float switch at the tank top that cuts power to the pump when water reaches full level. This protects the pump from running dry and reduces electricity use.
We assess the tank condition during our first visit and tell you whether repair or replacement makes sense before we fit the pump. If the tank stays, we mount the pump on the supply line rather than inside the tank.
