Roof-tank pump
Transfers water from ground tank to roof tank reliably.

Hawalli
Pump installation in Salam begins by checking the roof tank and the network pressure available. We choose the right pump type, run suction and delivery lines, fit check valves and set the pressure before startup.
Most Salam houses have four or five storeys with one or two roof tanks, and the pump needs a spot close to the well or main feed point. We check suction line length, number of bends and total head because all affect the pump size needed. If the well is distant, we fit a wider-bore suction pipe or raise the suction point to cut pressure loss.
Salam is in Hawalli governorate, a residential district of multi-storey houses that rely on roof tanks and pump systems.
After installation, the pump runs at full pressure for fifteen minutes to confirm temperature does not rise.
Transfers water from ground tank to roof tank reliably.
Keeps hot water at the tap without a long wait.
Sets correct cut-in and cut-out points, stops short-cycling.
Evacuates cesspits efficiently with a non-return valve fitted.
Lifts sewage from low-level units to the drainage network.
Protects basements from water accumulation via float-activated switch.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We measure pressure at the top point and check flow to each floor. If upper storeys have weak pressure, either the pump is undersized or there is a line leak that needs fixing.
Shallow pumps draw from nearby wells only seven metres deep, while submersible pumps lower into the well itself and push water straight upward. The location and depth of your well decide which type we install.
