Roof-tank pump
Transfers water from ground tank to roof tank reliably.

Jahra
Water pump installation in Uyoun starts by measuring network pressure and sizing the roof tank. We select a pump matching the head from the well or main line, fit the check valve and pressure gauge, and test flow and pressure before handover.
In Uyoun, most houses and residential buildings rely on roof-mounted tanks, meaning the pump must lift water from the main line to a height of eight to ten metres. We check the suction line from the main supply and ensure an air valve sits at the highest point, then mount the pump in a dry safe space. After first start, we test the pressure to confirm the tank fills steadily and the check valve seals tightly when power cuts.
Uyoun lies in Jahra governorate, an older residential area where most roof tanks sit at similar heights on single-storey houses.
Every pump is tested under full load for twenty minutes to verify stable pressure and electrical current draw.
Transfers water from ground tank to roof tank reliably.
Keeps hot water at the tap without a long wait.
Sets correct cut-in and cut-out points, stops short-cycling.
Evacuates cesspits efficiently with a non-return valve fitted.
Lifts sewage from low-level units to the drainage network.
Protects basements from water accumulation via float-activated switch.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Pressure depends on tank height above the pump. In Uyoun, we typically target operating pressure between 1.5 and 3 bar. We measure the actual rise and calculate required pressure, then select a pump with a slightly higher cut-off rating.
It is best to place the pump away from high humidity to extend its lifespan. A dry bathroom mounted on a wall away from direct spray can work. We always ensure cool air can reach the motor and warm air can escape.
