Roof tank installation
Polyethylene tank set on roof with supply, overflow and pump lines connected
Jahra
Water tank installation in Uyoun
Water tank installation in Uyoun begins with checking the roof or ground location earmarked for the tank. We size the tank based on occupant numbers and daily demand. We set the tank on a level concrete foundation and run supply, overflow and vent pipes. Every connection is tested for leaks before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Old Uyoun houses often relied on shallow wells and manual water collection, so modern roof tank installation transforms how the household consumes water. We measure tank height above the highest fixture in the house to ensure natural pressure. Supply from a well pump or the municipal line needs screening and a check valve to protect the well. Overflow and flushing require a separate drain to a ditch or soakpit.
Uyoun sits in Jahra governorate, a historic area near natural springs where reliance on groundwater remains strong.
Every pipe connection is pressure-tested immediately after installation because a small leak in the ground or roof may only show after weeks.
What the installation covers
Underground tank construction
Watertight underground tank built with access hatches and rising main connected
Inlet and supply lines
Mains supply connected to tank with float valve and isolation fitted
Overflow and drain lines
Overflow routed away from the building at correct fall to prevent backflow
Pump connection
Transfer or pressure pump connected to tank and tested under load
System pressure test
Full network pressure test after installation confirms every joint holds
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank installation
Other services in Uyoun
Water pipe runs
See the detailsWater pump install and service
See the detailsCentral gas lines
See the detailsFirst-fix plumbing for new houses
See the detailsCommon questions
Questions about Water tank installation in Uyoun
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the tank receive water from both a well and the municipal line at once?
Yes, but we fit a check valve on the well line and a pressure regulator on the municipal line to prevent cross-flow. The lines are separated by an air gap during filling.
How high above the house must the tank sit to give enough pressure?
Each metre of height gives roughly 0.1 bar pressure. Normal fixtures need 1 to 2 metres above the highest tap. We test the pressure with a gauge after fixing.
