Roof tank installation
Polyethylene tank set on roof with supply, overflow and pump lines connected
Hawalli
Water tank installation in Hateen
Water tank installation in Hateen accounts for the roofs and pipework of older homes built in the nineteen-fifties and sixties in this established Hawalli district. Technicians check an older roof's load capacity before any installation and connect the new tank to legacy pipework with extra care.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Hateen's older roofs were poured to older structural standards that may not safely bear the same weight as larger modern fittings, so we verify the concrete roof's condition and structural capacity before placing any new tank on it. These homes' older pipework is also often galvanized steel, which reacts chemically differently with modern plastic fittings, so we use suitable transition connectors that prevent early corrosion at the point where the two materials meet.
Hateen in Hawalli governorate is a mixed district of older homes and villas built from the nineteen-fifties through sixties with traditional roofs and pipework.
Old galvanized pipe in Hateen homes needs a transition connector when linked to a new tank or modern plastic pipework.
What the installation covers
Underground tank construction
Watertight underground tank built with access hatches and rising main connected
Inlet and supply lines
Mains supply connected to tank with float valve and isolation fitted
Overflow and drain lines
Overflow routed away from the building at correct fall to prevent backflow
Pump connection
Transfer or pressure pump connected to tank and tested under load
System pressure test
Full network pressure test after installation confirms every joint holds
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank installation
Other services in Hateen
Water pipe runs
See the detailsWater pump install and service
See the detailsCentral gas lines
See the detailsFirst-fix plumbing for new houses
See the detailsCommon questions
Questions about Water tank installation in Hateen
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can our old roof bear a larger modern tank?
We always check the roof first, since some older roofs need light reinforcement or a smaller tank split across two points instead of one heavy tank.
Why can't the new tank connect directly to our old galvanized pipes?
Old metal meeting modern plastic without a proper transition piece speeds corrosion at the joint, so we use a connector designed specifically for that purpose.
