Roof tank installation
Polyethylene tank set on roof with supply, overflow and pump lines connected
Hawalli
Water tank installation in Jabriya
Water tanks in Jabriya are fitted to spacious villa roofs and residential buildings near the American University. We size the tank by occupant count and daily consumption. We run supply and draw-off pipes, fit the float valve and pump and test everything.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Jabriya is a spacious family district with villas and gardens and modern residential buildings. Near Mubarak Hospital tanks are usually larger because villas here are deep and may need multiple lift pumps. We check roof height above the highest consumption point and calculate whether natural pressure is enough or a second pump is needed, and regulate pressure valves to ensure steady pressure on all floors.
Jabriya in Hawalli governorate is an upscale residential district where most villas and buildings have roof tanks.
Tank and pump are tested together at maximum pressure and pressure stability is checked at all consumption points.
What the installation covers
Underground tank construction
Watertight underground tank built with access hatches and rising main connected
Inlet and supply lines
Mains supply connected to tank with float valve and isolation fitted
Overflow and drain lines
Overflow routed away from the building at correct fall to prevent backflow
Pump connection
Transfer or pressure pump connected to tank and tested under load
System pressure test
Full network pressure test after installation confirms every joint holds
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank installation
Other services in Jabriya
Water pipe runs
See the detailsWater pump install and service
See the detailsCentral gas lines
See the detailsFirst-fix plumbing for new houses
See the detailsCommon questions
Questions about Water tank installation in Jabriya
Need someone now? The emergency line is open any hour.
+965 9668 4964
If a villa is deep and multi-storey does it need more than one pump?
Usually yes. A single pump may not deliver enough pressure to upper floors if the villa is very deep. We fit a first lift pump from the underground tank and an intermediate booster on the first floor to reinforce upper pressure.
How do we ensure pressure is steady throughout the villa?
We fit a pressure regulator on the main distribution line and test it at every consumption point before handover. Pressure must be 2 to 4 bar at all taps and outlets.
