Burner inspection
Clean and adjust the burner for even, complete ignition every cycle

Farwaniya
Gas heater repair in Omariya starts with unusual sounds or smells from the unit. We inspect the burner, fans, heat exchanger and test pressure, thermal range and safe flue venting.
Omariya suburban district has medium-sized family houses with gas heaters in utility cupboards or roof mounted. Winter increases heating loads and weak performance becomes obvious. We check the main gas valve, regulator and gas line for blockages, and clean the combustion chamber of ash and mineral salt. We inspect the heat exchanger inside and out for corrosion or scale buildup that cuts heat transfer to water.
Omariya sits in Farwaniya governorate, a suburban residential area with scattered family houses.
We run the heater at full water flow and measure temperature rise between inlet and outlet to calculate heat transfer efficiency.
Clean and adjust the burner for even, complete ignition every cycle
Test every joint with detection solution to locate any minor leak
Inspect the flue path and confirm combustion gases exit the space
Measure thermostat accuracy and test the thermal cut-off safety valve
Check the tank body and the sacrificial anode for corrosion progress
Measure incoming water pressure and confirm it suits the unit's rating
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, thick deposits form an insulating layer that cuts heat transfer to water and drops performance. We remove the exchanger and soak it in specialized cleaning solution then rinse with clean water and dry it before reassembling.
The thermostat sensor may be stuck or the safety valve too sensitive. We check the sensor by measuring its electrical resistance and test the valve by lighting the flame manually and watching its response.
