Burner inspection
Clean and adjust the burner for even, complete ignition every cycle

Jahra
Gas heater service in Subbiya focuses on maintaining safe performance in a humid coastal setting. We disassemble the burner, clean it of deposits, inspect the manifold pipes, safety valve and electrical parts and measure gas pressure.
Homes in Subbiya, near Sheikh Jaber causeway, face high humidity that causes rust in the burner, copper pipes and electrical terminals. Mineral deposits build up on burner ports, weakening gas flow and ignition. We carefully remove deposits, inspect the electrical insulation on the igniter and ensure the safety valve moves freely despite corrosion.
Subbiya sits in Jahra governorate near coastal zones, where salt spray and humidity raise the corrosion rate on gas equipment.
Igniter electrical current is tested after cleaning because coastal moisture weakens the contact between electrodes.
Clean and adjust the burner for even, complete ignition every cycle
Test every joint with detection solution to locate any minor leak
Inspect the flue path and confirm combustion gases exit the space
Measure thermostat accuracy and test the thermal cut-off safety valve
Check the tank body and the sacrificial anode for corrosion progress
Measure incoming water pressure and confirm it suits the unit's rating
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Moisture creeps between the igniter electrodes and blocks the spark. We dry the electrodes, check wiring and terminals and test voltage. We replace the igniter if corrosion is severe.
At least every six months because salt and humidity speed up buildup. We inspect, remove deposits and test ignition and pressure after each clean.
