Burner inspection
Clean and adjust the burner for even, complete ignition every cycle

Jahra
Gas heater inspection in Sulaibiya Industrial covers the regulator, burner, exchanger and high-pressure pipework. We test performance under full load and verify connection integrity before production resumes.
Small factories and warehouses in Sulaibiya Industrial use large gas heaters with pipework running across the building. These pipes suffer vibration from machinery and thermal expansion. We check every bracket and metal clamp to ensure pipes stay fixed, and inspect main lines for mechanical leaks and localized corrosion.
Sulaibiya Industrial zone in Jahra holds light factories and warehouses where heaters run under high pressure and continuous load.
Gas pressure is measured with a precision gauge and compared to the factory rating on the data plate.
Clean and adjust the burner for even, complete ignition every cycle
Test every joint with detection solution to locate any minor leak
Inspect the flue path and confirm combustion gases exit the space
Measure thermostat accuracy and test the thermal cut-off safety valve
Check the tank body and the sacrificial anode for corrosion progress
Measure incoming water pressure and confirm it suits the unit's rating
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, continuous vibration causes small cracks at welds, leading to gas leaks. We inspect every clamp, tighten bolts and add metal brackets where needed.
Usually it means the air port is clogged with dirt or carbon. We clean the burner and air opening and rebalance the gas-to-air ratio.
