Tank body inspection
Checking the outer shell and all joints for seepage or moisture
Ahmadi
Heater leak detection in Zour
Leak detection on Zour heaters focuses on massive tanks connected to power and desalination plants. We examine the tank body, return pipework and large valves under high pressure. We identify the source before losing large volumes of hot water.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Zour stations operate central heaters of huge capacity connected to wide distribution networks through insulated piping. A leak from a single joint may not show easily because water mixes with insulation or pools in lower network sections. We scan pipes with thermal imaging to trace abnormal cool spots, then disconnect joints one by one under partial pressure to narrow the area.
Zour sits in Ahmadi governorate and houses power and desalination plants that rely on large central heating systems.
We apply thermal imaging to detect heat loss on external pipes to locate the leak source quickly.
What the detection covers
Acoustic leak tracing
Pinpointing concealed leaks by sound without opening the wall
Camera line check
Running a camera into supply or drain lines to trace the moisture source
Pipe connection check
Inspecting inlet, outlet and surrounding fittings for weeping joints
Fuel or power side
Checking the area around fuel or power entries for secondary moisture sources
Leak location report
Delivering a clear finding on where the leak is and what repair is needed
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Heater leak detection
Other services in Zour
Electric heater repair
See the detailsGas heater service
See the detailsGeneral heater repair and service
See the detailsHeating element and thermostat
See the detailsCommon questions
Questions about Heater leak detection in Zour
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we find a leak in foam-wrapped insulated pipes?
We use thermal imaging to see the cold pattern on the insulation's outer surface even if water is not visible. Then we carefully remove the insulation in the suspicious area and inspect the pipe beneath.
Must we shut down the entire station to check for leaks?
Not always. We can test sections of the network under low partial pressure during normal operation. If we find a leak in a critical section, we may need a brief shutdown to drain and test it.
