Element condition check
Resistance measured to confirm whether element is scaled, shorted or open
Farwaniya
Heating element and thermostat in Khitan Al-Jadida
Element and thermostat repair in Khitan Al-Jadida begins with a full heater inspection to find why hot water is weak or cut off. We remove the element and test it with a meter, check thermostat wires and electrical connections. We replace the element or thermostat or both based on findings and restore full hot water.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Khitan Al-Jadida homes built in recent years have wall-mounted electric heaters in the kitchen or near the shower. These modern heaters have sealed elements and manual or automatic thermostats that switch heating on as temperature drops. When hot water stops across the whole house, the fault is usually the element itself or the wire linking it to the thermostat.
Khitan Al-Jadida lies in Farwaniya governorate, a new residential area where hot water in every flat is a basic need.
After fitting, the thermostat is tested at different temperature settings to confirm switching happens at the right point.
What this service covers
Thermostat testing
Cutout points tested and temperature calibration verified before fitting new part
Tank interior inspection
Scale deposits inside the tank assessed as they reduce heating efficiency
Sacrificial anode check
Anode protects the tank from corrosion and is inspected at every service visit
Electrical connections
Wiring and terminals inspected for safety before the new element is energised
Post-replacement test
Heater run and water temperature confirmed at the tap before the visit ends
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Heating element and thermostat
Other services in Khitan Al-Jadida
Gas heater service
See the detailsGeneral heater repair and service
See the detailsHeater leak detection
See the detailsSolar heater repair
See the detailsCommon questions
Questions about Heating element and thermostat in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you tell if the element is broken and not the wire or thermostat?
We remove the element from the heater and place it in a meter to check if it reads the correct ohms. If the meter shows zero or infinity the element is broken inside and must be replaced.
Must the heater power be switched off before we start?
Yes, we cut power at the circuit breaker before opening the heater or removing wires. After replacement we restore power and test water flow and temperature together.
