Collector panel check
Absorber tubes, flow channels and surface condition inspected for faults
Farwaniya
Solar heater repair in Khitan Al-Jadida
Solar heater repair in Khitan Al-Jadida starts by running pressure tests on the panels and tank to measure actual output. We inspect copper piping, insulation, the circulation pump and thermostat to find why water temperature has dropped. We draw a sample from the tank to check for mineral buildup and clean strainers as needed. Once done, the whole system runs under full pressure to verify recovery.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Khitan Al-Jadida houses are newly built with solar heaters mounted on flat roofs with clear space between panels and deck. This gap lets air circulate and lets us check pipes and insulation from below. When we descend to the pump room near the entrance, the storage tank sits close by, making sample collection and pump replacement easier. But long pipe runs from the roof lose heat if insulation is thin or sun-damaged.
Khitan Al-Jadida sits in Farwaniya governorate, a modern residential suburb with medium-density housing where solar heaters sit on most rooftops.
Every copper joint is tested for leaks because thermal cycling can weaken solder joints after years of sun exposure.
What the repair covers
Tank and insulation
Tank body, thermal insulation layer and sacrificial anode condition assessed
Circulation loop
Circulation pump, valves and connecting pipework between panel and tank
Thermostat and expansion
Thermostat calibration, expansion vessel pressure and safety valve checked
Leak detection
Acoustic and visual tracing of panel and pipe leaks before any breaking
Post-repair test
Pressure and temperature test confirms full output is restored before leaving
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Solar heater repair
Other services in Khitan Al-Jadida
General heater repair and service
See the detailsHeater leak detection
See the detailsHeating element and thermostat
See the detailsWater heater installation
See the detailsCommon questions
Questions about Solar heater repair in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the storage tank need cleaning every year?
It depends on water quality and insulation thickness. We inspect calcium deposits during every service and recommend flushing if white sediment appears in the sample.
Why does hot water reach the tap much slower than it used to?
The distribution pipes on the roof may have lost insulation, or the pump flow has weakened. We test pump flow and measure temperature where the pipes drop to the first floor.
