Element condition check
Resistance measured to confirm whether element is scaled, shorted or open
Hawalli
Heating element and thermostat in Salwa
Replacing the heating element and thermostat in a Salwa water heater starts with a full check of the tank and electrical thermostat condition. We remove the cover, test the element resistance and verify temperature reading before replacement. We install the new element and calibrated thermostat, fill the tank and test final temperature output.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Salwa has mid-range villas and modern apartment blocks with flat roofs carrying separate hot water tanks beside cooling tanks. This elevated, sun-exposed position means the thermostat works harder to hold temperature, especially in summer. We check the tank location and exposed piping runs on the roof before replacement, because bare hot pipes lose heat and may affect thermostat reading.
Salwa lies in Hawalli governorate, a residential district near Salwa Co-op and Mishref Park.
We test the new thermostat at multiple temperatures before handover because the elevated tank may delay heat transmission.
What this service covers
Thermostat testing
Cutout points tested and temperature calibration verified before fitting new part
Tank interior inspection
Scale deposits inside the tank assessed as they reduce heating efficiency
Sacrificial anode check
Anode protects the tank from corrosion and is inspected at every service visit
Electrical connections
Wiring and terminals inspected for safety before the new element is energised
Post-replacement test
Heater run and water temperature confirmed at the tap before the visit ends
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Heating element and thermostat
Other services in Salwa
Gas heater service
See the detailsGeneral heater repair and service
See the detailsHeater leak detection
See the detailsSolar heater repair
See the detailsCommon questions
Questions about Heating element and thermostat in Salwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the old thermostat give wrong readings or has it stopped working altogether?
We test the thermostat with a direct heat meter and compare its reading against what the tank shows. If the difference is more than one or two degrees, replacement is needed even if it still functions.
Do the roof pipe runs need insulation or wrapping after installation?
Bare hot pipes on Salwa roofs lose considerable heat in the sun. We recommend adding foam or fibreglass insulation to the main runs to improve tank efficiency and ease thermostat work.
