Pipe routing
Mapping every copper run before walls are plastered over

Ahmadi
The central gas network in Sabahiya runs gas from the main regulator outside the house to every appliance before plastering starts. Each joint is bubble-tested to verify no leaks, then results are recorded.
Sabahiya is a district of similarly sized and designed family homes near Ahmadi governorate, most with one kitchen and a central heating unit in the roof. The pipe layout is straightforward but needs even fall from the meter to each burner so moisture and contaminants do not collect. We use brass clamps every 1.5 metres to secure the pipe and protect bends from strain.
Sabahiya lies in Ahmadi governorate, a stable residential area where new housing projects are common.
Each Sabahiya gas branch is tested at 10 bar for three minutes because the residential sector here follows set government standards.
Mapping every copper run before walls are plastered over
Branching the network to each appliance position per plan
Fitting an isolation valve at every outlet for future servicing
Dry nitrogen charge and pressure hold test before handover
Core drilling wall openings and securing pipes with correct clips
Recording final pipe routes for future maintenance reference
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We mix water with soap and apply it to every joint under pressure. A small bubble that grows shows a leak, and we watch until bubbles stabilise. We undo the joint, re-clean it and reassemble it with extra thread tape.
Yes, wet concrete and salt corrode copper over time. We wrap the pipe with a breathable insulating tape that lets vapour pass but prevents direct contact with walls and cement.
