Pipe routing
Mapping every copper run before walls are plastered over

Hawalli
Gas network installation in South Surra runs pipes from the neighbourhood meter to kitchen and heating outlets in each unit. We pressure-test and check for leaks carefully before walls and ceilings close.
South Surra homes are usually simple mid-rise villas and flats with similar small kitchens and gas heating. We focus on the pipe route from the outdoor meter indoors, typically located near the building entrance. We use braided copper pipes that withstand heat and vibration, leaving inspection points at each bend because small leaks can appear months later.
South Surra sits in Hawalli governorate as a typical residential neighbourhood where small and medium housing units concentrate.
Each unit is tested separately because shared pipes in close houses can delay locating where a leak occurs.
Mapping every copper run before walls are plastered over
Branching the network to each appliance position per plan
Fitting an isolation valve at every outlet for future servicing
Dry nitrogen charge and pressure hold test before handover
Core drilling wall openings and securing pipes with correct clips
Recording final pipe routes for future maintenance reference
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We test from the main inlet valve just after the meter, because the meter is a measuring device and cannot take high pressure. Every pipe and outlet from that valve inward carries the full test.
The test confirms no large holes exist at handover, but very small leaks may not show immediately. We give you a period to spot-check visually and by smell in the first weeks.
