Electronic detection
sensors detect escaping gas through walls without any breaking
Capital
Gas leak detection in Dasman
Gas leak detection in Dasman starts with a full check of main feed lines and interior branches in flats and villas. We use electronic sensors and soapy water to pinpoint where gas is escaping. We identify the damage type and repair the joint or replace the damaged pipe section. Final testing includes pressure verification to confirm the line is safe.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Dasman has modern high-rise buildings and large villas with private courtyards, each supplied by gas lines starting from the city meter at the boundary wall. In tall blocks, main lines run through service risers on each floor, while in villas they run beneath floors or inside external walls. Old leaks often appear at joints where different metals meet or where concrete reinforcement presses on the pipe.
Dasman lies on the seafront between Arabian Gulf Street and the diplomatic quarter, where luxury villas and high-end residential blocks concentrate.
Every repair is tested under steady pressure for at least three minutes before the line is handed back for use.
What this service covers
Pressure test
network segments isolated and pressure drop measured to find the faulty section
Joint inspection
every joint and valve checked with leak-detection fluid where leakage is suspected
Source isolation
gas isolated to the faulty section immediately to keep the building safe
Line repair
only the damaged section repaired or replaced, rest of network left intact
Final pressure check
full pressure test after repair confirms the entire network is tight
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Gas leak detection
Other services in Dasman
Kitchen gas lines
See the detailsRestaurant gas lines
See the detailsCentral gas first-fix
See the detailsPlumbing installations
See the detailsCommon questions
Questions about Gas leak detection in Dasman
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do I know if the leak is in the main line and not the cooker?
We close the appliance stopcock and run the detector on the main line alone. If the detector keeps sounding, the leak is before the appliance in the fixed pipe. We trace the line from the meter until we pinpoint the exact spot.
Must we evacuate the flat while you repair the line?
A simple joint repair takes minutes and can be done with occupants inside. However, if we need to work on the main stopcock, we ask for the gas to be fully shut off and the flat ventilated before we start.
