Plumbing and electrics first-fix
Coordinating pipe and conduit routes before screed is poured
Ahmadi
First-fix plumbing and electrics in Fahad Al-Ahmad
First-fix plumbing and electrics in Fahad Al-Ahmad means laying every pipe and wire before the builder closes the walls. We mark pipe routes on the plans, run copper supply and waste under floor slabs, and install electrical conduits before concrete is poured.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Fahad Al-Ahmad is a suburban area of modern family villas with separate kitchens, multiple bathrooms and open living spaces. The kitchen needs hot and cold supply lines and a separate grease trap distinct from main drainage, and secondary bathrooms need pipes buried in wall cavities before tiling. From first-fix we run pipes in set routes under floor slabs and inside wall chases per the plans so they do not cross electrical runs.
Fahad Al-Ahmad sits in Ahmadi governorate, a modern residential development where most villas are still passing through different build phases.
Before walls close, every water line is tested under hydraulic pressure to check joints because reopening walls later becomes very costly.
What this covers
Bathroom first-fix
Drain, supply and power points set to exact fixture positions
Kitchen first-fix
Water, drain and electrical lines serving appliances and sinks
Apartment first-fix
Full first-fix for units in multi-storey residential buildings
Drainage first-fix
Drain pipes laid at correct falls with required vent openings
Tanks and pump connections
Ground tank, roof tank and pressure pump pipe connections
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for First-fix plumbing and electrics
Other services in Fahad Al-Ahmad
Apartment first-fix
See the detailsBathroom first-fix
See the detailsDrainage first-fix
See the detailsKitchen first-fix
See the detailsCommon questions
Questions about First-fix plumbing and electrics in Fahad Al-Ahmad
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we keep water pipes from crossing electrical wires in the walls?
We use the building plans to mark separate routes for each pipe and wire type before cutting or laying anything. We maintain safe spacing between runs and document everything before walls are closed.
When should water lines be tested during first-fix?
After all copper pipes and fittings are laid but before the builder adds insulation over walls. We fill the system and apply pressure for at least two hours to detect leaks at any joint.
