Plumbing and electrics first-fix
Coordinating pipe and conduit routes before screed is poured
First-fix plumbing for new houses
Pipe and wire routes laid right before walls close
Correct routing from the start keeps water, drain and electrical lines out of conflict and prevents costly tile-breaking later
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What this covers
Combined plumbing and electrical first-fix for new residential and commercial builds
Bathroom first-fix
Drain, supply and power points set to exact fixture positions
Kitchen first-fix
Water, drain and electrical lines serving appliances and sinks
Apartment first-fix
Full first-fix for units in multi-storey residential buildings
Drainage first-fix
Drain pipes laid at correct falls with required vent openings
Tanks and pump connections
Ground tank, roof tank and pressure pump pipe connections
How the job runs
Call or WhatsApp
Share building drawings and current construction stage
Drawing review
Pipe routes and rough-in points identified before site visit
Site visit
Construction stage confirmed and coordination with other trades done
First-fix installation
Supply, drain and conduit runs installed with water pressure test
Handover and records
As-built pipe route drawing handed over with pressure test record
Signs this work is needed now
Structure has reached roof level
Ideal window to run pipes and conduits before screed and plaster close them in
Pipe and conduit routes clash
Water pipes crossing electrical conduits or drain lines without prior coordination
Fixture positions changed late
Moving a basin or toilet position requires resetting rough-in points before walls close
No pressure test done
Supply network entered finishing stage without a leak test to catch early faults
Common first-fix mistakes to avoid
Running trades separately
Separate execution without coordination leads to clashes found only after plastering
Ignoring heater position early
Fixing heater position after finishing forces exposed pipe runs and extra cost
No as-built drawing
Closing walls with no pipe route drawing turns every future repair into guesswork
Ignoring thermal pipe expansion
Kuwait's summer heat expands PPR pipes and rigid fixing without allowance causes cracking
More in first-fix plumbing for new houses
Bathroom first-fix
See the details
Kitchen first-fix
See the details
Apartment first-fix
See the details
Drainage first-fix
See the detailsPart of First-fix plumbing for new houses · All services · Back to the home page
What decides the price
No fixed rate applies; these factors shape the quote for each job
Floors and units
Each floor adds vertical risers and horizontal runs to the scope
Pipe material specification
Specified pipe type and diameter directly affects material and labour cost
Electrical conduit complexity
Number of distribution boards and cable runs determines electrical scope
Heater system type
Central heater systems need longer distribution runs than individual units
Trade coordination required
Concurrent work with AC or structural contractors adds coordination requirements
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Sanitary fixture installation
- Cistern and mixer repair
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Water pipe leak repair
Restaurants
- Restaurant gas lines
- Gas leak detection
- Kitchen plumbing runs
- Water pump install and service
Complexes and buildings
- Building and complex maintenance
- Roof tank and basement pumps
- Water tank installation
- Operation and maintenance contracts
Why us
Why Al Amana for first-fix plumbing and electrics
Amana means trust. Someone else’s home is not ours to be careless in.
Photographed before and after
Do not take our word for it. Look at the work yourself.
We find it before we break it
The leak is marked before a single tile comes up.
24-hour emergency
A leak does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
We cover all of Kuwait
Six governorates, 139 areas.
CapitalHawalliFarwaniyaAhmadiMubarak Al-KabeerJahra
Common questions
Questions about first-fix plumbing and electrics
Need someone now? The emergency line is open any hour.
+965 9668 4964
What is the difference between plumbing first-fix and electrical first-fix in a build?
Plumbing first-fix covers supply and drain pipe runs and rough-in points before walls close. Electrical first-fix covers conduits and distribution boards. Running both together prevents route conflicts hidden inside walls.
Why does coordination between plumbing and electrics matter at this stage?
Water pipes and electrical conduits share the same wall and ceiling cavities. Poor route planning means breaking tiles later to reroute. Early coordination resolves conflicts before plaster and screed seal them in.
Can bathroom rough-in points be moved after screed is poured?
Changes are possible but require breaking the screed and possibly finished tiles, raising cost considerably. Finalising fixture positions before the screed is poured is always the right approach.
How does Kuwait's heat affect first-fix pipes in new buildings?
High summer temperatures cause PPR pipes to expand, so each fixing point needs a movement allowance. Older galvanised iron pipes are stressed by both heat and the mineral content of Kuwaiti water.
What documentation do you provide after the first-fix is complete?
We hand over an as-built drawing showing water, drain and electrical conduit routes inside walls and ceilings, along with the pressure test report confirming the supply network is sound before it is sealed.
