Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Capital
Mixer repair in Abdullah Al-Salem starts with checking the internal valve, seals and springs before full disassembly. We identify the root cause of a leak or weak flow, then replace only the damaged parts without swapping the entire mixer. Hot and cold supply and drainage are tested before we leave.
In Abdullah Al-Salem villas, ground-floor kitchens have mixers at the sink edge or on upper counters, many leaking under the bowl or showing weak cold flow. Older mixers have springs that rust and seals that harden fast because of hard water. We disassemble the mixer, clean scale deposits from the cartridge, fit new parts and balance the water pressure.
Abdullah Al-Salem sits in Kuwait governorate, a villa and family housing district where most mixers are older and need regular maintenance.
Every repaired mixer is tested after fitting through three open-close cycles to confirm the internal valve holds without leaking.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Usually replacing the seal rings and internal spring is enough, and it costs less than a new mixer. We open the mixer and inspect each part before deciding what to replace.
Usually from scale buildup in the cold inlet opening or a partial blockage in the valve seat. We disassemble the mixer, flush the passages with descaling fluid and test the pressure afterwards.
