Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Hawalli
Mixer and faucet repair in Bidaa
Mixer repair in Bidaa handles long hot water line issues that slow response and cause under-sink leaks. We check copper pipes for leaks and cracks, clean the mixer from debris, replace connection seals if needed. We run all lines at high pressure before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Bidaa houses have long hot water lines running from the heater to kitchen and bathroom, and these old lines often leak at joints. When we arrive we inspect every copper fitting on the hot line from heater to mixer, tighten any loose connection and replace worn rubber seals. If we find a tiny pinhole leak in the pipe itself we suggest replacing that pipe section or applying temporary sealant tape.
Bidaa is a residential area in Hawalli near Salmiya seafront, with family houses and flats of varying ages and old plumbing systems.
We pressurize the hot line to 2 bar for 10 minutes to reveal any small leak that would not show under normal flow.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Bidaa
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Bidaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does cold water come first before hot when opening the mixer?
Because the long hot line needs minutes to fill from the heater. This is normal in Bidaa where the heater is far from the kitchen. We ask residents to run the water and wait for air to vent.
Does bathroom humidity cause the mixer to lose flow pressure?
No, but humidity speeds corrosion of seals and springs inside the mixer. We recommend annual inspection and seal replacement before they fail.
