Supply pipework
Hot and cold PPR lines run inside walls to each fixture

Jahra
Bathroom and kitchen plumbing in Jahra New starts with reading the building plan and locating load-bearing columns. We set out hot and cold supply runs and waste routes, then pressure-test everything before walls are tiled and painted.
Most villas in Jahra New follow a similar layout of concrete columns and flat slab floors, which means drain pipes need a steady fall under floor tiles or within external walls. Kitchens are usually far from bathrooms, so we run separate supply lines and insulate hot water pipes to prevent heat loss. Bathrooms near Jahra New Co-op require longer drain routes that may need a pump if they sit below the main sewer level.
Jahra New lies in Jahra governorate, a modern villa district with a main street near Jahra Hospital and Jahra New Co-op.
Every run is pressure-tested at 10 bar for half an hour before walls are closed, because slow leaks only show at full pressure.
Hot and cold PPR lines run inside walls to each fixture
uPVC drain pipes set at correct fall to prevent sediment buildup
Dishwasher, sink and grease-trap connections run and tested
Individual valve per circuit so one fixture shuts off independently
Network pressurised before plastering to expose any weak joint
Toilets, basins and mixers connected after final finishes are complete
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, we fit separate isolation valves for each area so the family does not lose water to the entire house for a small repair. The valves are easily placed inside under-sink cabinets or near external walls.
We use copper or polypropylene depending on budget and design. Copper lasts longer but costs more and is harder to fit; polymer is faster and easier but needs insulation on hot runs.
