Position and level
Pan set level and aligned to the waste outlet centre for proper drainage

Jahra
Western toilet installation in Qasr starts with measuring available space and checking the floor underlay. We select pan and cistern size to fit the gap, then connect cold water and waste with tight tolerances.
Qasr homes range from modern to older builds with many having simple undecorated bathrooms. We check floor reinforcement before tightening anchor bolts because older construction may not withstand high point load. We use a flexible filler under the outlet flange to distribute weight evenly.
Qasr is a residential area in Jahra governorate located near Al Qasr Co-op.
We test the cistern with repeated full fills and rapid flushes to confirm the overflow mechanism works precisely.
Pan set level and aligned to the waste outlet centre for proper drainage
Wax ring or rubber gasket fitted between pan base and the floor outlet flange
Braided flexible supply tail and a dedicated isolation valve fitted to the cistern
Cistern mounted and float valve adjusted for correct fill level and full flush
Sanitary silicone bead around the pan base stops water tracking under the tile
Multiple flush cycles run immediately after fitting to confirm all joints are dry
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Often yes if the old anchor points match the new pan closely. We may need to fill old holes with filler and drill new ones if the position shifts slightly.
We place a flexible foam pad under the flange directly before final bolting. We then test by pouring large volumes of water quickly and watching underneath the tiles for any seepage.
