Pipe repair
PPR, uPVC and corroded galvanised iron joints and runs
Hawalli
Plumber (sabbak) in Salwa
Plumbing repair in Salwa starts by checking joints and valves before a leak spreads into house walls. We locate the fault in copper or plastic pipe and fix it with a replacement fitting without wall damage if possible. Early detection stops moisture damage that targets foundations in this area. We test pressure right after the repair.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Salwa houses around Salwa Co-op have long supply pipes running from the street to the home, and these pipes leak at old joints first. We inspect exposed runs under the kitchen and bathroom because corrosion starts there, especially on poor-grade copper. Where a joint is buried in the wall, precise chiselling rather than hammering is essential to fix the fault without enlarging the opening.
Salwa sits in Hawalli governorate near Mishref Park, a single-home district where age and extensions have damaged original pipework.
We test supply pressure after every repair because long distribution pipes hide small leaks.
What a sabbak handles
Mixers and valves
repair or replacement of leaking or stiff mixers and isolation valves
Water pressure
tracing low pressure to scale buildup, a blocked aerator or a pump fault
Fixture installation
fitting toilets, cisterns, basins and floor drains correctly and leak-free
Post-repair check
pressure test on the line after every repair before closing the wall
Fault diagnosis
locating the exact fault before any decision to break or repair
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Plumber (sabbak)
Other services in Salwa
Master plumber
See the details24-hour emergency plumber
See the detailsWater pump install and service
See the detailsWater tank cleaning
See the detailsCommon questions
Questions about Plumber (sabbak) in Salwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do I tell if a leak is in the pipes or the roof tank?
First shut off the meter supply and watch the floor and walls; if the leak stops, the tank is fine and the pipes are faulty. We trace lines under tiles and plaster from kitchen to bathroom to find the leak point.
Does fixing an old joint mean removing the entire pipe?
No, we use a small coupling fitting that matches the pipe diameter and remove only that section without touching other runs. We take out the bad joint, fit the new coupling with tight connections and test the flow.
