Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Capital
Epoxy tank lining in Gharnata
Epoxy tank lining in Gharnata protects older tanks from cracks and seeps caused by heat expansion. We drain the tank and jet all debris and algae with high-pressure water. We sand interior walls and apply epoxy to specification, then camera-inspect every corner and seam before returning to service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Houses in remote Gharnata have old bare-concrete roof tanks, and extreme heat and nighttime cold cause cracks and slow leaks. We inspect cracks visually and with a camera first to detect structural damage needing repair before coating. If cracks are surface-level only, epoxy fills them and stops water and moisture seeping from outside.
Gharnata is an outer residential zone in Kuwait City, remote from main services where tank maintenance is harder and slower.
We record camera images of every tank wall right after coating to document the final condition for the customer.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Gharnata
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Gharnata
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a tank with visible cracks be coated, or must it be repaired first?
It depends on crack depth. Surface cracks under 2 mm are filled by epoxy, but through-thickness cracks need structural repair with special cement first.
After coating, how long must we wait before running the pump?
Yes, allow at least 48 hours for full epoxy cure before pumping water onto it under pressure. Leave the tank sealed and bone dry during this time.
