Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Capital
Epoxy tank lining in Dasma
Epoxy tank lining in Dasma begins with complete drainage and scraping internal walls free of rust and sediment deposits. We apply primer coat then finish coat and lower an inspection camera to ensure no cracks or voids remain beneath the coating.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Many older residential buildings in Dasma have underground tanks beneath courtyards or on roofs, and their thin walls rust quickly from hard water. Epoxy coating bonds to concrete only after scraping to smooth and removing all salt and oxide, and we clean every speck of dust with high-pressure water before painting begins. If we find a fine crack we fill it with epoxy putty first, because paint alone will not seal deep voids.
Dasma lies in the capital near the old commercial centre, a dense residential area with multi-level water tanks in most buildings.
Each epoxy coat must cure for twenty-four hours before the next is applied, because internal moisture affects coating adhesion.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Dasma
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Dasma
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we know if the old coating must be fully stripped?
If the old coating is flaking or lifting from the wall it must be fully removed because new epoxy will not bond to it. We test adhesion by gently raising the scraper edge on a small patch first.
Must the tank be completely empty before we start work?
Yes, walls cannot be scraped or painted with water present. We ensure all connected pipes are drained and leave the vent open throughout so walls dry completely before coating begins.
