Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Gharnata
Tank welding in Gharnata addresses damage from poor maintenance and harsh desert conditions on aging plastic storage tanks. Strong sun makes plastic brittle and fragile, causing small cracks that expand over time. We assess material brittleness and use specialist weld compatible with weakened plastic, then test the result before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Building tanks in outer-suburb Gharnata are old exposed plastic units sitting fully open to sun and sand-laden winds. Plastic exposed to over a decade of UV rays becomes brittle and prone to breakage. When we arrive we inspect for fine cracks and white discoloration that signal surface degradation.
Gharnata is a residential zone in Kuwait governorate in the outer suburbs where older homes and tanks are widespread.
We test old plastic under slow pressure rise because aged tanks may fail under rapid pressurization immediately after welding.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Gharnata
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Gharnata
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is a 15-year-old sun-damaged tank worth repairing or better to buy new?
If the crack is small and single, not multiple, repair costs less and takes less time. But if the whole surface shows brittleness signs we suggest replacement because more cracks will appear soon.
After welding an old tank, how long before new cracks appear?
It depends on sun exposure intensity. If fully exposed new cracks may appear within a year or two. We recommend a heat-reflective coating on the surface after welding to slow plastic degradation.
