Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Hawalli
Epoxy tank lining in Ministries Area
Epoxy tank lining in the Ministries Area protects water tanks exposed to harsh seasonal changes. We fully drain the tank, clean walls by scraping and sanding, apply rated epoxy layers and test for leaks before refilling.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Government buildings in the area hold large rooftop tanks to meet high demand during long working hours. These tank walls face direct sun and daily temperature swings, causing fine cracks in steel and concrete. Epoxy flexes with thermal expansion and seals both visible and microscopic cracks, stopping water loss and preventing interior rust. Before coating, we camera-inspect the tank floor and walls for existing weak spots.
The Ministries Area sits in Hawalli governorate, where central government buildings are equipped with tanks under severe thermal stress.
Every tank is tested by slow filling for a full hour to catch any seepage before handover.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Ministries Area
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
Must the tank be completely drained before epoxy coating?
Yes, it must be fully emptied and ventilated because moisture prevents epoxy adhesion. We use a sump pump and wait for walls to dry before scraping and cleaning.
How long does the entire epoxy coating job take from start to finish?
Usually three days: draining and cleaning on day one, epoxy coats on days two and three with drying time between. Then we slowly refill and inspect before handover.
