Inspection and mapping
Internal camera maps every crack and spalled area before work starts
Hawalli
Water tank restoration in Ministries Area
Ministries Area depends on large rooftop tanks to feed its massive government buildings with water throughout the day. Restoration includes inspecting the tank body inside and out, treating rust and cracks, applying specialist protective coating and returning it to service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Government buildings around the Civil Service Commission are tall structures needing robust tanks on high roofs. These tanks face harsh sun and desert dust that accelerate paint failure and interior metal corrosion. We inspect the tank floor and corners for leaks, calcium deposits and rust that builds white or brown layers. Where corrosion exists we abrade rust back to bare steel, then spray thick epoxy coating to shield against internal moisture.
Ministries Area in Hawalli houses the State's chief administrative buildings, where water systems must stay stable and reliable.
Every restored tank is tested under full water pressure for one hour before handover because slow leaks only show under real load.
What restoration covers
Surface preparation
All scale, efflorescence and loose material removed before any filler is applied
Crack filling
Hydraulic mortar seals active and dry cracks in concrete walls and floor
Wall levelling
Repair render restores corroded or pitted wall surfaces to a uniform face
Protective coating
Drinking-water rated coating applied over fully cured and prepared surfaces only
Post-work check
Camera confirms coating integrity and joint sealing before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank restoration
Other services in Ministries Area
Fibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsUnderground tank cleaning
See the detailsCommon questions
Questions about Water tank restoration in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you know if rust has eaten through the tank wall?
We use a steel gauge to measure wall thickness at several points and look for blisters or swelling that signal tiny holes leaking slowly. If thickness falls below safe limits we recommend replacement instead of restoration.
After repair and coating, how long before the tank can safely hold water again?
Epoxy coating needs at least eight hours to fully cure in Kuwait's heat. We leave the tank open to air, fill it slowly and monitor for any seepage before reconnecting the distribution lines.
