Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Jahra
Epoxy tank lining in Naeem
Epoxy coating in Naeem begins by opening the underground tank and vacuuming all remaining water and mud from the bottom. We scrape walls with a stiff metal brush, then dry the tank with compressed air before applying epoxy in two successive coats.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Naeem is a relatively older residential area, and its underground tanks were often built in the nineties without interior coating. Moisture from damp soil and seasonal shifts in groundwater level cause slow erosion of bare concrete walls. Epoxy coating stops this erosion and improves water quality by preventing salts from old concrete from leaking into stored water.
Naeem is a residential neighborhood in Jahra governorate, containing many villas and family homes with large underground tanks.
Epoxy thickness is measured with a magnetic gauge after drying to ensure the coat meets minimum specifications.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Naeem
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Naeem
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does an old tank need repairs before epoxy coating?
We inspect the tank first, and if we find small cracks in the walls, we fill them with cement filler before coating. If cracks are large or in the base, the tank may need structural repair before epoxy coating will be effective.
What happens if the epoxy coat cracks after application?
Cracking is rare if the coat is applied correctly, but if it occurs, it is usually from movement in the underlying concrete. We visit to check the source of movement and repair cracks with an additional epoxy layer after cleaning.
