Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Naeem
Tank welding in Naeem begins with thorough inspection of cracks and weak joints in the tank body. We apply cold or hot weld depending on material type and test the repair by filling the tank and watching for seepage.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Naeem houses rely on plastic or fibreglass tanks mounted on the roof or in the yard to hold filtered water. These tanks face sun and repeated pressure and small cracks develop around the fill and drain fittings. When we arrive we inspect all cracks and test existing joints because one repair may uncover weakness elsewhere. We weld cracks inside and outside depending on depth and material, then test under live water.
Naeem is a residential area in Jahra governorate that relies on private wells and in-home filtration to feed the tanks.
After welding we fill every tank and wait at least one hour before leaving because slow seepage may not show at once.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Naeem
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Naeem
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can we repair cracks in the tank bottom without draining it completely?
Yes, we can reach lower cracks from inside after draining only a portion of water. We weld the crack and leave the tank full to test the repair before use.
What if the tank leaks from the fill fitting itself, not from a crack?
We remove the fitting and inspect the seal ring and threads. If the ring is worn we replace it, and if the threads are damaged we reweld the fitting with a fresh seal.
