Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Farwaniya
Epoxy tank lining in Rabiya
Epoxy lining in Rabiya protects residential water tanks from rust and leaks long-term. We start by draining the tank completely and chemical cleaning, followed by deep sanding of the steel surface. We spray epoxy under pressure in multiple coats and finish with camera inspection.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Family homes in Rabiya residential area have roof tanks for storing fresh water. These tanks face direct sun and night humidity, often showing red and black rust. Epoxy provides a barrier coating that prevents water from contacting the steel walls directly. We focus on inspecting weld quality at corners and joints, as these are structurally weaker. After coating we fill slowly and wait hours before connecting to the house to ensure complete adhesion.
Rabiya lies in Farwaniya governorate and is an established residential zone with traditional and modern family homes.
We pressure-test the tank with air before filling because any cracks in the coating show immediately under pressure.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Rabiya
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Rabiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can epoxy withstand high roof temperatures in summer heat?
Yes, industrial epoxy is designed to withstand high temperatures. The tank itself stays slightly cooler than outside air because water inside acts as natural insulation. The coat does not crack from heat alone.
If a small crack appears in the coat after a year, can it be patched without full recoating?
Yes, small cracks can be patched with local epoxy filler. We expose the crack, sand lightly and fill it with matching epoxy. A simple repair is far cheaper than full recoating.
