Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Farwaniya
Epoxy tank lining in Rai Industrial
Epoxy lining of large tanks in Rai Industrial requires coordination with production and storage schedules. We assess tank size and wall thickness, then schedule drainage and coating over several days to minimize downtime.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Rai Industrial tanks are very large and store drinking water or industrial wash water for long periods. Their reinforced concrete walls corrode from salt and bacterial buildup on the inner surface. We drain with powerful pumps then use high-pressure cleaning equipment to strip all organic layers and hard deposits. After full drying with compressed air we apply epoxy in multiple thin coats rather than one thick coat.
Rai Industrial sits in Farwaniya next to The Avenues Mall, an industrial area where most buildings have large storage tanks.
We verify epoxy strength by sampling each batch of mixed material before application to the walls.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Rai Industrial
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Rai Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How many days will the tank be out of service during coating?
Usually four days: one for drainage and cleaning, two for coating, one for drying and inspection. If the tank is very large it may take longer.
Do you test-fill the tank with water right after coating?
We test-spray light water on walls before full refilling to check for acute leaks. Full filling happens one day after coating is done.
