Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Rai Industrial
In Rai Industrial, large rooftop tanks supplying offices and warehouses endure severe mechanical stress from heavy pipes connected to them. Repairing the welds on these tanks requires complete drainage, pressure-testing under one thousand litres per hour, then welding the crack with reinforced metal rod.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Rai Industrial buildings are relatively modern with fibreglass and heavy-gauge plastic tanks mounted on concrete pads. Near The Avenues complex, tanks take high flow because the buildings use heavy water and pipe pressure increases wall crack risk. On site we inspect tank mounting on the pad first, because pump vibration causes branching cracks. If cracking stems from loose mounting we fix the metal anchor bolts and roller feet before welding the wall.
Rai Industrial lies in Farwaniya governorate, an industrial-commercial zone where multi-storey buildings have massive tanks operating under high pressure.
At each inspection we record leak rate in millilitres per minute to track whether the crack grows under repeated pressure.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Rai Industrial
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Rai Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Must the building stop using water while the tank is being repaired?
Yes, we drain the tank completely and the pump cannot run during repair. The work usually takes four hours including drying and testing, so we work night shifts or weekends when usage drops.
What if there is more than one crack in the tank?
We weld each crack separately with full cooling intervals between them. We pressure-test each one before moving to the next because rushed welding weakens quality.
