Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Farwaniya
Epoxy tank lining in Ardhiya Industrial
Epoxy tank lining in Ardhiya Industrial starts with complete drainage and chemical cleaning of the steel surface. We sand away rust and sediment, then spray the epoxy coat under pressure. The finish is checked with an industrial camera before refilling.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most factories and warehouses near Ardhiya Refinery depend on large steel tanks for water and chemical storage, and these tanks corrode quickly in the coastal climate. Epoxy lining protects the internal walls from rust and leaks for years without replacing the tank itself. We focus on cleaning every corner and weld seam before coating, because any trapped moisture weakens the finish. Industrial spray equipment ensures even epoxy distribution across the entire inner surface.
Ardhiya Industrial lies in Farwaniya governorate, a zone specializing in heavy industry and storage where protected tanks are essential.
The tank is dried with compressed air after cleaning because any moisture prevents epoxy adhesion.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Ardhiya Industrial
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Ardhiya Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How long until the epoxy coat cures and the tank is ready to use?
The coat dries to touch within hours, but needs three full days before filling the tank with water or chemicals. We leave the tank open to air throughout the curing period.
Can epoxy protect the tank from acid chemical attack inside?
Yes, but we choose the epoxy type based on what will be stored. For strong acids we use acid-resistant formulation. A sample is tested before full coating application.
