Crack mapping by camera
Internal camera maps every crack and its depth before work begins
Capital
Fibreglass tank repair in Mansouriya
Fibreglass tank repair in Mansouriya requires careful inspection to locate every leak before any work starts. We identify the full source of water loss, clean the tank interior and apply sealed resin. Every repair is pressure-tested under actual conditions to confirm the leak has stopped.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Villas in Mansouriya near Mansouriya Co-op rely on fibreglass roof tanks because ground space for underground tanks is limited. These tanks face extreme roof temperatures, especially in summer when the material expands significantly. This repeated expansion and contraction stresses the tank walls and creates small cracks that develop slowly. We inspect every wall under strong light and probe each crack with water-sensitive paste.
Mansouriya sits in Kuwait governorate near Fourth Ring Road, a dense residential area where roof tanks are the main storage solution.
We test the tank by pumping water continuously for one hour and measuring any level drop that shows remaining leaks.
What the repair covers
Surface preparation
Grinding the area around the crack ensures the resin bonds properly
Glass-mat laminate patch
Resin-saturated glass-mat layers fill the crack and restore structural stiffness
Delamination and wear repair
Delaminated sections are removed and rebuilt with matching laminate material
Drinking-water epoxy coat
Full interior coat with epoxy rated safe for potable water contact
Post-repair camera check
Camera confirms no remaining cracks or coating bubbles before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Fibreglass tank repair
Other services in Mansouriya
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Fibreglass tank repair in Mansouriya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do cracks appear in fibreglass tanks years after installation?
Fibre expands and contracts with temperature and moisture changes at a different rate than resin, creating internal stress. Over years this stress translates to small cracks in the walls, especially in high-heat zones.
Can the tank be repaired without draining all the water?
No, the tank must be completely drained and the interior dried before applying any resin or protective coating. Water prevents resin from bonding properly to fibre walls and weakens the repair.
