Crack mapping by camera
Internal camera maps every crack and its depth before work begins
Capital
Fibreglass tank repair in Shuwaikh
Fibreglass tank repair in Shuwaikh starts with full drainage and inspection of the walls for hairline cracks and seepage. We locate every fault and test stress points around the base seams. We clean the interior surface and seal each defect with waterproof epoxy resin. We refill, wait hours and then return the tank to service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuwaikh has warehouses and commercial offices with fibreglass roof tanks sitting on flat surfaces, exposed to intense heat and drying. The problem is hairline cracks only show when the tank fills completely, then water beads appear on the outside. We open the tank and wipe the walls with dry cloth to spot faint seepage lines, then search for weak points at corners and the bottom outlet.
Shuwaikh lies in Kuwait city near the Kuwait Science Museum, a light commercial and industrial zone with water tanks raised on roofs.
Every repaired tank is tested by slow filling and holding pressure steady for two hours because small cracks only show under constant load.
What the repair covers
Surface preparation
Grinding the area around the crack ensures the resin bonds properly
Glass-mat laminate patch
Resin-saturated glass-mat layers fill the crack and restore structural stiffness
Delamination and wear repair
Delaminated sections are removed and rebuilt with matching laminate material
Drinking-water epoxy coat
Full interior coat with epoxy rated safe for potable water contact
Post-repair camera check
Camera confirms no remaining cracks or coating bubbles before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Fibreglass tank repair
Other services in Shuwaikh
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Fibreglass tank repair in Shuwaikh
Need someone now? The emergency line is open any hour.
+965 9668 4964
How often should my roof fibreglass tank be inspected?
We inspect when you first see leakage or slow refill. In Shuwaikh with high heat, an annual check before summer helps catch cracks early before they spread.
Can a fibreglass tank be repaired while it still holds water?
No, it must be completely drained first because water masks seepage paths and stops resin from gripping the surface. We run the drain pump and let the walls dry fully before starting repairs.
