Crack mapping by camera
Internal camera maps every crack and its depth before work begins
Jahra
Fibreglass tank repair in Mutlaa
Fibreglass tanks atop the Mutlaa ridge need thorough inspection due to fierce winds, dust and harsh weather swings. We ascend to the tank with safe equipment and enter from the top to see lower walls and base. We reveal cracks starting around internal supports and fill them with weather-resistant flexible epoxy compounds.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Mutlaa homes sit at height where winds are strong and soil is shallow sand. Tanks face open air directly and endure wind pressure from one side at times. Water inside helps balance but cracks form on the wind-facing wall or where fibre is weak. We inspect the tank from every side for wind impact and fractures, then test each repair under pressure.
Mutlaa is a high ridge in Jahra known for desert landscape and fierce winds, and resident tanks endure sharp atmospheric pressures.
Before leaving site we fill the tank to maximum and wait two hours monitoring joints and cracks for any new drips.
What the repair covers
Surface preparation
Grinding the area around the crack ensures the resin bonds properly
Glass-mat laminate patch
Resin-saturated glass-mat layers fill the crack and restore structural stiffness
Delamination and wear repair
Delaminated sections are removed and rebuilt with matching laminate material
Drinking-water epoxy coat
Full interior coat with epoxy rated safe for potable water contact
Post-repair camera check
Camera confirms no remaining cracks or coating bubbles before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Fibreglass tank repair
Other services in Mutlaa
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Fibreglass tank repair in Mutlaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Are wind-facing cracks more dangerous than other cracks?
Yes, because constant wind pressure pushes the wall outward and widens cracks slowly. We fill wind cracks deeper and test them under pressure simulating strong wind.
Does the tank need protective paint after repair?
No in most cases, if cracks seal well and plugs are flexible. But if the outer wall is sun-eroded we may suggest reflective paint to protect the fibres.
