Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Abdali
Tank welding in Abdali repairs tanks installed in homes and animal pens on the border road between farming and residential zones. We detect cracks by pressurizing a filled tank, clean joints of salt and dirt, weld the crack with controlled heat and seal-test for two hours before reuse.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Homes and small farms near Kinanah residential in Abdali use mixed plastic and fibreglass tanks exposed to strong winds and sandstorms. Tanks mounted on simple metal frames move with gusts, causing rotational stress in tank walls and cracks at the weakest weld points. We also inspect bolts and metal joints because rust can weaken the tank mounting itself.
Abdali in Jahra is a border area near Iraq where farms mix with residential zones and tanks face seasonal winds.
Before welding, we assess expected wind speed at the site and choose weld type that tolerates rotational stress rather than rigid welds.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Abdali
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Abdali
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do strong winds affect weld quality while we are working?
Yes, wind cools the weld rapidly and disrupts thermal contact. We work on calm-wind days or use temporary glass barriers around the weld zone to shield it from gusts.
Should the tank mounting bolts be tightened more firmly after welding?
No, over-tightening causes new cracks because fresh weld is still brittle. We advise checking bolts after one week, and if bolts are rusty replace them before they cause added movement.
