Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Jahra Industrial
Tank welding in Jahra Industrial repairs large tanks in factories and companies. We locate the leak by pumping water at high pressure, clean the crack precisely and apply steady heat to seal it tight and safely.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Jahra Industrial is full of large factories and production units using massive plastic and fibreglass tanks subject to high daily pressure. Tanks expand and contract with temperature swings, causing gradual weakening of joints and thin walls. When a leak is found we drain the tank quickly and mark the leak site permanently. We sand the crack from all angles and remove debris or moisture with a wire brush and compressed air. We apply heat with precise control to fuse the layers without weakening nearby zones.
Jahra Industrial is a specialised factory zone in Jahra governorate, where large tanks operate under harsh conditions year-round.
After repair we raise pressure gradually over thirty minutes to test the welded crack under full load.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Jahra Industrial
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Jahra Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a crack in a pressurised tank be repaired without draining?
No, pressure prevents proper cleaning and drying of the crack. Pumping must stop and the tank must be fully drained before any welding to ensure repair safety.
What if a new leak appears near the first repair?
It may signal wider wall weakness. We inspect the full zone closely and repair all fine cracks at once before full refill.
