Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Abu Halifa
Tank welding in Abu Halifa treats cracks from pressure and wear in old plastic and fibreglass tanks. We find the crack by visual check and water testing, then clean the area and apply a tight weld that prevents leak return. The tank then becomes safe and fault-free.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
In Abu Halifa near Abu Halifa Co-op, most houses are older and have long-lived water tanks under roofs or on surfaces. These are plastic and fibreglass, over ten years old in many cases, so they crack at joints and the base. Heavy water pressure acts constantly on tank walls, and any weakness in old welds shows as slow leaks. Before new welding we inspect the entire tank base and check metal fitting strength. If damage is at the bottom, the tank must be fully drained.
Abu Halifa sits in Ahmadi governorate near Ahmadi Town, an older district where people have lived for many decades.
The tank is filled with cold water after welding and the repair site monitored for four hours before success is confirmed.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Abu Halifa
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Abu Halifa
Need someone now? The emergency line is open any hour.
+965 9668 4964
My old water tank is leaking from the base. Can it be fixed?
If the base is leaking, it can be repaired by strong welding after full drainage. We check base thickness first to confirm it will hold the weld, and if it is very thin we suggest internal reinforcement as well.
Is welding the tank cheaper than buying a new one?
Welding costs far less than replacement if the damage is localized. We assess the tank first and advise the most cost-effective and strongest option.
