Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Anjafa
Tank welding in Anjafa treats cracks and loose joints in overhead tanks on detached family homes. We pinpoint the leak location precisely, partially drain the tank, weld with suitable material and pressure-test.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Anjafa is a district of detached villas, and roof tanks here are usually large because homes need bigger storage. Cracks happen from heavy weight, intense heat and uneven expansion in tank walls. We install a safe ladder on the roof to inspect the tank fully, measure wall thickness, look for weak spots and tap lightly to listen for internal voids. Welding starts after complete drying and testing confirms the tank can hold its new weight.
Anjafa sits in Hawalli, a residential area of detached villas where each roof tank bears significant weight.
We fill the welded tank to maximum level and hold it full for six hours then inspect the exterior for any seepage.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Anjafa
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Anjafa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the weld weaken if the tank stays full all the time?
Fresh weld is strong under static pressure, but repeated filling and draining tires the weld. In Anjafa where villas are large and use is high, we advise against fully draining the tank, keep a quarter of water in it.
If a long crack exists can we weld only the ends?
No, the entire crack must be welded end to end. Welding only the ends leaves the middle open and pressure will spread the gap. We weld a continuous line then test.
