Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Shuhada
Earlier repairs are the main obstacle to tank welding in Shuhada, where many older tanks carry smears of silicone, epoxy putty or tape over past leaks. A weld cannot bond to any of them, so we strip every old patch back to clean plastic before the new repair starts.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Silicone and putty hide a crack without closing it, and water keeps tracking underneath until the patch lifts. We scrape and grind each old repair away, then look at what is left: sometimes a small crack, sometimes a wider split that the patch allowed to grow. The true crack is welded properly, and if the plastic around several old patches has thinned too far, we say so and recommend a replacement instead.
Shuhada is a Hawalli governorate residential district of family houses, many with rooftop tanks repaired more than once.
In Shuhada, every earlier silicone or putty patch is ground off before a new weld is attempted.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Shuhada
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Shuhada
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why did the silicone repair on my tank fail?
Silicone sits on top of the crack rather than fusing with it. Water works underneath and the patch lifts, usually after a hot season.
Can you weld over an old patch?
No. The weld needs clean plastic, so the old material is removed completely first.
