Crack welding
direct thermal weld along each fracture line in the tank wall

Farwaniya
Tank welding in Rehab starts with a full inspection of the plastic or fibreglass tank for cracks and leaks. We locate damage and choose the right welding method for the material and crack size. We prepare the surface, weld every break and pressure-test the tank before handover.
Most Rehab houses have water tanks mounted on low roofs or fixed to upper-floor bathroom walls, and these tanks face direct sun heat and repeated expansion. Cracks usually appear at fixing points and corners where pressure concentrates most. We test every weld by filling the tank and leaving it for hours to catch slow seeps. If the crack runs deep or multiple joints are leaking, we may suggest tank replacement instead of repair.
Rehab lies in Farwaniya governorate, a residential family area where households rely on roof tanks to keep water pressure steady throughout the day.
We test welds by pumping water under steady pressure for at least an hour because a small leak may not show with filling alone.
direct thermal weld along each fracture line in the tank wall
re-welding inlet and outlet fittings where the flange joint has failed
resin-and-mat layer over the damaged zone before the final weld seal
internal camera after welding reveals any weak point before refilling
replacing the tank lid when the leak source is the cover seal
written record of weld locations and camera inspection result
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Welding strength depends on the original material quality more than its type. Thick plastic tanks weld more strongly than thin fibreglass ones. We check wall thickness first before deciding the best repair method.
Do not refill for at least six hours until the polyurethane weld fully cures. We leave a time-marked tape on the tank, and you can resume normal use safely after that.
